|
|
COMMUTATOR PLACING UNIT
MCP-14
STANDARD FEATURES
Quick change tooling.
All fluidic operation.
Adaptable for tooling to accommodate tang or slotted commutators.
Easily adjustable for radial and linear position.
DESCRIPTION
The Model MCP-14 is a manual load/unload unit designed to assemble commutators to the armature shaft. Both tang and slotted commutators can be accommodated on this versatile unit utilizing quick change tooling fixtures. The unit is offered as a bench mounted unit or optionally on a fabricated stand.
OPERATION
Armature cores are loaded into a keyed nest for positive radial alignment and commutators are loaded into an adjustable nosepiece where they are located radially either by tangs, or in the case of non-tang commutators, by the commutators’ slots. The commutators are pressed into position by a pneumatic cylinder or optional hydraulic powered cylinder.
OPTIONS
Hydraulic power system.
Fabricated stand.
MACHINE SPECIFICATIONS
Electrical Requirements
One (1) KVA.
Pneumatic Requirements
One (1) SCFM @ 80 PSI (Approximately 0.03 cubic meter/minute)
Machine Dimensions (approximate)
Manual load/unload = 40” x 40” x 55” (1.02 x 1.02 x 1.4m)
Chain transfer style = 60” x 64” x 55” (1.50 x 1.65 x 1.4m)
armature Capacities
Description
Minimum
Maximum
Lamination Diameter
13 mm (0.500 inch)
76 mm ( 3.000 inches)
Stack Length
19 mm (0.750 inch)
102 mm ( 4.000 inches)
Shaft Length
38 mm (1.500 inches)
254 mm (10.000 inches)
Shaft Diameter
3 mm (0.125 inch)
22 mm ( 0.875 inch)
Commutator Diameter
7 mm (0.250 inch)
57 mm ( 2.250 inches)
Commutator Length
5 mm (0.190 inch)
51 mm ( 2.000 inches)
Commutator End Shaft Extension
6 mm (0.250 inch)
76 mm ( 3.000 inches)
Stack to Commutator
13 mm (0.500 inch)
25 mm ( 1.000 inch)
